[单选题]
Refer to the exhibit. What will happen to HTTP traffic coming from the Internet that is destined for
A. Traffic will be dropped per line 30. of the ACL.
B. Traffic will be accepted per line 40. of the ACL.
C. Traffic will be dropped, because of the implicit deny all at the end of the ACL.
D. Traffic will be accepted, because the source address is not covered by the ACL.

[单选题]
Refer to the exhibit. What type of connection would be supported by the cable diagram shown?
A. PC to router
B. PC to switch
C. server to switch
D. switch to router

[单选题]
Refer to the exhibit. What statement is true of the configuration for this network?
A. The configuration that is shown provides inadequate outside address space for translation of thenumber of inside addresses that are supported.
B. Because of the addressing on interface FastEthernet0./1., the Serial0./0. interface address will not supportthe NAT configuration as shown.
C. The number 1. referred to in the ip nat inside souce command recerences access-list number 1..

[单选题]
Refer to the exhibit. What can be determined about the router from the console output?
A. No configuration file was found in NVRAM.
B. No configuration file was found in flash.
C. No configuration file was found in the PCMCIA card.
D. Configuration file is normal and will load in 15. seconds.

[多选题]Refer to the exhibit. What could be possible causes for the "Serial0./0. is down" interface status? (Choosetwo.)
A. A Layer 1. problem exists.
B. The bandwidth is set too low.
C. A protocol mismatch exists.
D. An incorrect cable is being used.
E. There is an incorrect IP address on the Serial 0./0. interface.

[单选题]
Refer to the exhibit. What is the meaning of the output MTU 150.0. bytes?
A. The maximum number of bytes that can traverse this interface per second is 150.0..
B. The minimum segment size that can traverse this interface is 150.0. bytes.
C. The minimum segment size that can traverse this interface is 150.0. bytes.
D. The minimum packet size that can traverse this interface is 150.0. bytes.
E. The maximum packet size that can traverse this interface is 150.0. bytes.
F. The maximum frame size that can traverse this interface is 150.0. bytes.

[单选题]
Refer to the diagram. What is the largest configuration file that can be stored on this router?
A. 191.K bytes
B. 163.84.K bytes
C. 313.69.K bytes
D. 114.688.K bytes

[单选题]
Refer to the exhibit.What is the reason that the interface status is “administratively down,line protocol
Down”?
A. There is a mismatch in encapsulation types
B. The wrong type of cable is connected to the interface
C. The interface has been configured with the shutdown command
D. The interface is not receiving any keepalives
E. The interface needs to be configured as a DTE device
F. There is no encapsulation type configured

[多选题]
Refer to the exhibit. What commands must be configured on the 295.0. switch and the router to allowcommunication between host 1. and host 2.? (Choose two.)
A. Router(config)# interface fastethernet 0./0.Router(config-if)# no shut down
B. Router(config)# interface fastethernet 0./0.Router(config-if)# no shut downRouter(config)# interface fastethernet 0./0..1.Router(config-subif)# encapsulation dot1.q 10.Router(config-subif)# interface fastethernet 0./0..2.Router(config-subif)# encapsulation dot1.q 20.
C. Router(config)# router eigrp 100.
D. Switch1.(config)# vlan databaseSwitch1.(config-vlan)# vtp domain XYZSwitch1.(config-vlan)# vtp server
E. Switch1.(config)# interface fastethernet 0./1.Switch1.(config-if)# switchport mode trunk
F. Switch1.(config)# interface vlan 1.

[单选题]
Refer to the exhibit.What is the effect of the configuration that is shown?
A. It tells the router or switch to try establish an SSH connection first and if that fail to use telnet.
B. Itconfigures a cisco network device to use the SSH protocol on incoming communications via the virtualterminal ports.
C. It allows seven failed login attempts before the VTY lines are temporarily shutdown.
D. It configures SSH globally for all logins.

[单选题]
Refer to the exhibit.What is the result of setting the no login command?
A. The is a virtually limitless supply of IP addresses
B. Telnet access requires a new password at first login
C. Telnet access requires a password
D. Telnet access is denied

[多选题]
Refer to the exhibit.What two results would occur if the hub were to be replaced with a switch that is
Configured with one Ethernet VLAN?(choose two)
A. The number of collision domains would decrease.
B. The number of collision domains would increase.
C. The number of broadcast domains would remain the same.
D. The number of collision domains would remain the same.
E. The number of broadcast domains would increase.

[多选题]
Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that isshown? (Choose two.)
A. Router1. has specific boot system command that instruct it to load IOS from TFTP server.
B. Router1. is acting as a TFTP server for other routers.
C. Router1. cannot locate a valid IOS image in flash memory.
D. Router1. defaulted to ROMMON mode and loaded the IOS image from a TFTP server.
E. Cisco routers will first attempt to load a image from TFTP for management purposes.

[单选题]
Refer to the exhibit. What does the (*) represent in the output?
A. Packet is destined for a local interface to the router.
B. Packet was translated, but no response was received from the distant device.
C. Packet was not translated, because no additional ports are available.
D. Packet was translated and fast switched to the destination.

[多选题]
Refer to the exhibit. What two facts can be determined from the WLAN diagram? (Choose two.)
A. The area of overlap of the two cells represents a basic service set (BSS).
B. The network diagram represents an extended service set (ESS).
C. Access points in each cell must be configured to use channel 1..
D. The area of overlap must be less than 10.% of the area to ensure connectivity.
E. The two APs should be configured to operate on different channels.

[单选题]
What will happen if a private IP address is assigned to a public interface connected to an ISP?
A. Addresses in a private range will be not routed on the Internet backbone.
B. Only the ISP router will have the capability to access the public network.
C. The NAT process will be used to translate this address in a valid IP address.
D. Several automated methods will be necessary on the private network.
E. A conflict of IP addresses happens, because other public routers can use the same range.

[单选题]
Refer to the exhibit. When running OSPF, What would cause router A not to form an adjacency with routerB?
A. The loopback addresses are on different subnets.
B. The value of the dead timers on the router are different.
C. Route summarization is enabled on both routers.
D. The process indentifier on router A is different than the process identifier on router B

[单选题]117. What _____ would happen if the director knew you felt that way?
A.do you suppose
B.you suppose
C.will you suppose
D.you would suppose

[单选题]149 A web server is being overloaded with HTTPS traffic. To decrease the load on the server, the LTM Specialist and the Server. Administrator decide to perform SSL offloading on the LTM device. The configuration of the virtual server is as follows:
Which change must be made to the configuration to perform SSL offloading?
A.Remove the clientssl and http profiles
B.Remove the clients profile
C.Remove the clientssl and serverssl profiles
D.Remove the severssl profile

[单选题]120 AN LTM Specialist is setting up a new HTTPS virtual server to decrypt client traffic. SNAT the traffic and send the encrypted traffic to the poor member, the client's IP address must be included in the traffic sent to the pool member.
What is a complete set of profiles that must be configured for the virtual server to meet these requirements?
A.TCP, Client SSL, Server SSL
B.TCP , Server SSL, HTTP
C.TCP, Client SSL, HTTP
D.TCP, Client SSL, Server SSL, HTTP