更多"Which configuration component is re"的相关试题:
[单项选择]Which method loads the configuration which was active before your last commit?()
A. load replace last-active
B. load rollback 1
C. rollback 1
D. rollback last-active
[单项选择]Which configuration is required for a Vocera badge to function properly on a Cisco WLC?()
A. disable higher data rates
B. set DTIM = 1
C. disable RRM
D. disable broadcast SSID
E. disable multicast
[单项选择]Given the following LSP configuration, which statement is true?()label-switched-path lsp-xyz { to 10.200.1.1; primary path1; secondary path2; secondary path3; no-cspf; } path path1 { 10.200.10.1 strict; } path path2 { 10.200.20.1 strict; } path path3 { 10.200.30.1 loose; }
A. The router will use path1 when it is available and stable.
B. The router will use path3 when it is available and stable.
C. The router will attempt to establish path2 only when path1 and path3 are down.
D. The router will attempt to establish path1 only when path2 and path3 are down.
[单项选择]Assuming the default switch configuration,which approach should you use to configure the extended vlan range(1006 through 4094) on a cisco catalyst 3750 series switch?()
A. Configure the switch to be in VTP client mode.
B. Configure the switch to be in VTP domaint mode.
C. Configure the switch to be in VTP transparent mode.
D. Configure the switch to be in VTPv2.
[单项选择]assuming the default switch configuration which vlan range can be added modified and removed on a cisco switch?()
A. 2 through 1001
B. 1 through 1001
C. 1 through 1002
D. 2 through 1005
[单项选择]What is required for the minimum configuration of the TS7650 ProtecTIER Appliance console? ()
A. 50 MB of available disk space and 128 MB of RAM
B. 100 MB of available disk space and 256 MB of RAM
C. 200 MB of available disk space and 512 MB of RAM
D. 300 MB of available disk space and 512 MB of RAM
[单项选择]Which configuration command configures queue buffer allocation on the ERX Edge Router?()
A. qos-profile
B. queue-profile
C. scheduler-profile
D. traffic-shape-profile
[单项选择]Which configuration shows the correct application of a security policy scheduler?()
A. [edit security policies from-zone Private to-zone External] user@host# show policy allowTransit { match { source-address PrivateHosts; destination-address ExtServers; application ExtApps; } then { permit { tunnel { ipsec-vpn myTunnel; } scheduler-name now; } } }
B. [edit security policies from-zone Private to-zone External] user@host# show policy allowTransit { match { source-address PrivateHosts; destination-address ExtServers; application ExtApps; } then { permit { tunnel { ipsec-vpn myTunnel; } } } scheduler-name now; }
C. [edit security policies from-zone Private to-zone External] user@host# show policy allowTransit { match { source-address PrivateHosts; destination-address ExtServers; application ExtApps; } then { permit { tunnel { ipsec-vpn scheduler-name now; } } } }
D. [edit security policies from-zone Private to-zone External] user@host# show policy allowTransit { match { source-address PrivateHosts; destination-address ExtServers; application ExtApps; scheduler-name now; } then { permit { tunnel { ipsec-vpn myTunnel; } } } scheduler-name now; }myTunnel;
[单项选择]Which configuration command permits dynamic detection of the ATM frame format?()
A. aal5mux
B. aal5snap
C. aal5dynamic
D. aal5autoconfig
[单项选择]Which configuration command dynamically detects and configures a PPPoA interface?()
A. auto-configure ip
B. auto-configure ppp
C. auto-configure pppoe
D. auto-configure bridgedethernet
[单项选择]Which profile configuration command dynamically creates a host route in the routing table?()
A. ip host routes
B. ip access-routes
C. host routes enabled
D. access-routes enabled
[多项选择]Which connections allow the use of full-duplex Ethernet?()
A. Switch to host
B. Switch to switch
C. Hub to hub
D. Switch to hub
E. Host to host
[单项选择]Which content network component maintains original source content and publishes content to the network edge?()
A. Content switch
B. Content router
C. Content engine
D. Content Distribution Manager (CDM)
[单项选择]Which configuration command creates a virtual router called isp-1?()
A. virtual-routerisp-1
B. virtual-routerISP-1
C. virtual-routerVRisp-1
D. virtual-routerVRISP-1