更多"[单选题]Which term describes a spannin"的相关试题:
[单选题]
Which term describes the process of encapsulating IPv6. packets inside IPv4. packets?
A. tunneling
B. hashing
C. routing
D. NAT
[单选题]
Which statement describes the process of dynamically assigning IP addresses by the DHCP server?
A. Addresses are allocated after a negotiation between the server and the host to determine the length ofthe agreement.
B. Addresses are permanently assigned so that the hosts uses the same address at all times.
C. Addresses are assigned for a fixed period of time, at the end of the period, a new request for anaddress must be made.
D. Addresses are leased to hosts, which periodically contact the DHCP server to renew the lease.
[单选题]Which of the following best describes Titterton's job on stage?
A.Well-paid.
B.Dangerous.
C.Boring.
D.Demanding.
[单选题]Which of the following best describes the breeding programme?
A.Ambitious.
B.Successful.
C.Controversial.
D.Costly.
[多选题]
Which of the following describes the roles of devices in a WAN? (Choose three.)
A. A CSU/DSU terminates a digital local loop
B. A modem terminates a digital local loop
C. A CSU/DSU terminates an analog local loop
D. A modem terminates an analog local loop
E. A router is commonly considered a DTE device
F. A router is commonly considered a DCE device
[单选题]
Which type of EIGRP route entry describes a feasible successor?
A. a primary route,stored in the routing table
B. a backup route,stored in the routing table
C. a backup route,stored in the topology table
D. a primary route,stored in the topology table
[单选题]
Which name describes an IPV6. host-enable tunneling technique that uses IPV4. UDP,does not require
Dedicated gateway tunnels,and can pass through existing IPV4. NAT gateways?
A. dual stack
B. dynamic
C. Teredo
D. Manual 6.to4.
[单选题]
Which network protocol does DNS use?
A. FTP
B. TFTP
C. TCP
D. UDP
E. SCP
[单选题]
Which command helps a network administrator to manage memory by displaying flash memory andNVRAM utilization?
A. show secure
B. show file systems
C. show flash
D. show version
[单选题]Which network is used by vSphere HA when VMware vSAN is enabled?
A. Management network
B. vSphere Replication network
C. vMotion network
D. VSAN network
[单选题]
The network administrator has discovered that the power supply has failed on a switch in the company LAN
And that the switch has stopped functioning. It has been replaced with a Cisco Catalyst 295.0. series switch.
What must be done to ensure that this new switch becomes the root bridge on the network?
A. Lower the bridge priority number.
B. Change the MAC address of the switch.
C. Increase the VTP revision number for the domain.
D. Lower the root path cost on the switch ports.
E. Assign the switch an IP address with the lowest value.
[单选题]
A network administrator is troubleshooing an EIGRP problem on a router and needs to confirm the IP
Addresses of the devices with which the router has established adjacency. The retransmit interval and the
Queue counts for the adjacent routers also need to be checked. What command will display the required
Information?
A. Router# show ip eigrp adjacency
B. Router# show ip eigrp topology
C. Router# show ip eigrp interfaces
D. Router# show ip eigrp neighbors
[单选题]
A network administrator is troubleshooting the OSPF configuration of routers R1. and R2.. The routers
Cannot establish an adjacency relationship on their common Ethernet link. The graphic shows the output of
The show ip ospf interface e0. command for routers R1. and R2.. Based on the information in the graphic,
What is the cause of this problem?
A. The OSPF area is not configured properly.
B. The priority on R1. should be set higher.
C. The cost on R1. should be set higher.
D. The hello and dead timers are not configured properly.
E. A backup designated router needs to be added to the network.
F. The OSPF process ID numbers must match.
[单选题]
A network administrator is verifying the configuration of a newly installed host by establishing an FTP
Connection to a remote server. What is the highest layer of the protocol stack that the nework administrator
Is using for this operation?
A. application
B. presentation
C. session
D. transport
E. internet
F. data link
[单选题]
A network interface port has collision detection and carrier sensing enabled on a shared twisted pair
Network. From this statement, what is known about the network interface port?
A. This is a 10.Mb/s switch port.
B. This is a 100.Mbs switch port.
C. This is an Ethernet port operating at half duplex.
D. This is an Ethernet port operating at full duplex.
E. This is a port on a network interface card in a PC.
[多选题]A network administrator changes the configuration register to 0.x214.2. and reboots the router. What are tworesults of making this change? (Choose two.)
A. The IOS image will be ignored.
B. The router will prompt to enter initial configuration mode.
C. The router will boot to ROM.
D. Any configuration entries in NVRAM will be ignored.
E. The configuration in flash memory will be booted.
[单选题]
A network administrator needs to configure a serial link between the main office and a remote location.The
Router at the remote office is a non-cisco router. How should the network administrator configure the serial
Interface of the main office router to make the connection?
A. Main(config)#interface serial 0./0.Main(config-if)#no shut
B. Main(config)#interface serial 0./0.Main(config-if)#encapsulation ietfMain(config-if)#no shut
C. Main(config)#interface serial 0./0.Main(config-if)#encapsulation frame-relayMain(config-if)#authenication chapMain(config-if)#no shut
D. Main(config)#interface serial 0./0.Main(config-if)#encapsulation pppMain(config-if)#no shut
[单选题]108 The network team introduces a new subnet 10.10.22.0/24 to the network. The route needs to be configured on the F5 device to access this network via the 30.30.30.158 gateway.
How should the LTM Specialist configure this route?
A. Tmsh modify net route 10.10.22/24 gw 30.30.30.158
B. Tmsh create net route 10.10.22/24 gw 30.30.30.158
C. Tmsh changey net route 10.10.22/24 gw 30.30.30.158
D. Tmsh add net route 10.10.22/24 gw 30.30.30.158
