更多"[多选题] 使用display nat session 命令查看NAT"的相关试题:
[单选题]使用_____命令查看NAT 表项。
A.display nat table
B.display nat entry
C.display nat
D.display nat session
[单选题]要查看NAT数据包的debug 信息,应使用__( )____命令打开debug 信息并输出到显示器上。
A. terminal monitor
Debugging nat
B. terminal debugging
Debugging nat
C. terminal monitor
Terminal debugging
Debugging nat packet
D. terminal monitor
Terminal debugging
Debug nat
* 个人观点:在华三的设备上,想要查看某一具体调试信息,首先敲两个命令(terminal monitor、terminal debugging)。故选C。
[单选题]要查看NAT数据包的debug 信息,应使用______命令打开debug 信息并输出到显示器上。
A.terminal monitor<br />
Debugging nat<br />
B.terminal debugging<br />
Debugging nat<br />
C.terminal monitor<br />
Terminal debugging<br />
Debugging nat packet<br />
D.terminal monitor<br />
Terminal debugging<br />
Debug nat<br />
[单选题]在MSR 路由器上,使用_____命令查看路由器的NAT 老化时间。
A.display nat time
B.display nat expire
C.display nat aging-time
D.display nat time-out
[单选题]TDCS中使用showinterface命令查看路由器接口如显示lineisdown说明
A.接口故障
B.接口正常
C.协议正常
D.协议故障
[单选题]在GER上显示NAT的统计数据命令是:( )
A.show ip nat statistics
B.show ip nat count
C.show ip nat translations
D.show ip nat
[单选题]查看服务器磁盘大小并带有单位显示磁盘信息使用( )命令
A.df -r
B.df -s
C.df -h
D.df -e
[单选题]在MSR 路由器上,如果想查看NAT 转换的报文数量,应该使用______命令。
A.display nat counter
B.display nat
C.display acl
D.display nat session
[单选题]把ACL与IP policy,NAT等命令相关联,它指定了分组、地址、流,为与这些路由器特性相关而必须符合的标准。以这种方法使用的ACL被称为( )
A.服务ACL
B.接口ACL
C.策略ACL
D.以上都不是
[多选题]使用命令查看小区状态时,下列说法正确的是:
A.在lccm容器中进行检查
B.在brs容器中进行检查
C.使用命令showCellState查看
D.使用cellshow命令查看
[判断题]思科防火墙板卡开启nat-control命令后,如果不涉及地址转换,则不需要配置NAT转换命令。
A.正确
B.错误
[单选题]在MSR 路由器上,使用_____命令配置NAT 地址池。
A.nat address-group
B.nat ip pool
C.nat net pool
D.nat pool