更多"The following configura tion exists"的相关试题:
[单项选择] The following configuration exists on a router on one end of an IPv6 tunnel. Although the configuration added so far is correct, the configuration is incomplete. Which type of tunnel is most likely to be intended by the network engineer？（） interface loopback 1 ip address 192.168.1.1 255.255.255.255 interface tunnel 2 ipv6 address 2002:C0A8:10 1::1/64 tunnel source loopback 1
A. Automatic 6to4
B. Manually configured tunnel
C. ISATAP
D. GRE
[多项选择] Examine the following configuration on Router R1. R1's show ip route 172.16.4.1 command list s a route with outgoing interface S0/1/1. Host 172.16.3.3 uses telnet to connect to host 172.16.4.1.What will Router R1 do with the packets generated by host 172.16.3.3 because of the telnet,assuming the packets enter R1's F0/0 interface?（） interface Fastethernet 0/0 ip address 172.16.1.1 255.255.255.0 ip policy route - map Q2 ! route - map Q2 permit match ip address 101 set interface s0/0/1 ! access - list 101 permit tcp host 172.16.3.3 172.16.4.0 0.0.0.255
A. The packet will be forwarded out S0/0 /1, or not at all.
B. The packet will be forwarded out S0/0/1 if it is up.
C. The packet will be forwarded out S0/1/1 if it is up.
D. The packet will be forwarded out S0/1/1 if it is up, or if it is not up, out s0/0/1.
E. The packet will be forwarded o ut S0/0/1 if it is up, or if it is not up, out s0/1/1.
[多项选择] The following output on Router R1 lists details of a BGP route for 190.1.0.0/16. Which of the following is true based on this output?（） R1# show ip bgp 190.1.0.0/16 BGP routing table entry for 190.1.0.0/16, version 121 Paths: (1 available, best #1, table Default - IP - Routing - Table) Advertised to update - groups: 1 1 2 3 4 1.1.1.1 from 2.2.2.2 (3.3.3.3) Origin IGP, metric 0, localpref 100, valid, internal, best
A. R1 has a neighbor 1.1.1.1 command configured.
B. R1 has a neighbor 2.2.2.2 command configured.
C. The show ip bgp command lists a line for 190.1.0.0/16 with both a n > and an i on the left.
D. R1 is in ASN 1.
[多项选择]Which two of the following Cisco router platforms support Multicast Distributed Fast Switching?（）
A. 3600 series
B. 7200 series with NSE-1
C. 7500 series
D. 12000 series
[多项选择]Which of the following describe router functions?（）
A. Packet switching
B. Collision prevention on a LAN segment
C. Packet filtering
D. Broadcast domain enlargement
E. Broadcast forwarding
F. Internetwork communication
[多项选择]Which of the following commands causes a router to bring down BGP neighbor relationships?（）
A. clear ip bgp *
B. clear ip bgp 1.1.1.1
C. clear ip bgp * soft
D. clear ip bgp 1.1.1.1 out
[单项选择] The following was issues on router TestKingA: TestKingA #show ip ospf neighbor Neigbor ID PRI State Dead Time Address Interface 192.168.1.2 1 Full/- 00:00:37 192.168.1.2 Serial1 Which type of OSPF network will provide the output shown in the graphic?（）
A. FDDI
B. nonbroadcast multiaccess
C. broadcast multi-access
D. point-to-point
[单项选择] The following output occurs on Router R1. Which of the following cannot be determine d from this output?（） R1# show ip route 180.1.1.0 255.255.255.240 Routing entry for 180.1.1.0/28 Known via "bgp 2", distance 20, metric 0 Tag 3, type external Last update from 192.168.1.2 00:10:27 ago Routing Descriptor Blocks: * 192.168.1.2, from 19 2.168.1.2, 00:10:27 ago Route metric is 0, traffic share count is 1 AS Hops 2 Route tag 3
A. The type of BGP peer (iBGP or eBGP) that advertised this route to R1
B. R1's ASN
C. The next - hop router's ASN
D. The AS_Path length
[单项选择] The following output occurs on Router R2. Which of the following statements can be confirmed as true based on the output from R2?（） R2# show ip policy Interface Route map Fa0/0 RM1 Fa0/1 RM2 S0/0/0 RM3
A. R2 will forward all packets that enter Fa0/0 per the PBR configuration.
B. R2 will use route map RM2 when determining how to forward packets that exit interface Fa0/1.
C. R2 will consider using PBR for all packets exiting S0/0 /0 per route map RM3.
D. R2 will consider using PBR for all packets entering S0/0/0 per route map RM3.
[单项选择] The following output occurs on Router R1 , which runs both EIGRP for IPv6 and OSPFv3, with redistribution from EIGRP into OSPF configured with the redistribute eigrp 1 metric 25 command. Interface S0/0/1 has been enabled for EIGRP ASN 1. Which of the following should be true of redistribution in this case?（） D 2000::/64 [90/1422516] via FE80::213:19FF:FE7B:5026, Serial0/0/ 1 C 2000:0:0:1::/64 [0/0] via Serial0/0/1, directly connected L 2000::1:213:19FF:FE7B:5004/128 [0/0] via Serial0/0/1, receive
A. Route 2000::/64 will be redistributed.
B. Route 2 000:0:0:1::/64 will be redistributed.
C. Route 2000:1:213:19FF:FE7B:5004/128 will be redistributed.
D. No routes will be redistributed because of the omission of the subnets parameter of the redistribute command.
[单项选择] The following output occurs on Router R1. IP SLA operation 1 uses an ICMP echo operation type, with default frequency of 60 seconds. The operation pings from address 1.1.1.1 to address 2.2.2.2. Which of the following answers is true reg arding IP SLA and object tracking on R1?（） R1# show track Track 2 IP SLA 1 state State is Up 3 changes, last change 00:00:03 Delay up 45 secs, down 55 secs Latest operation return code: OK Latest RTT (millisecs) 6 Tracked by: STATIC - IP - ROUTING 0
A. The tracking return code fails after the SLA operation results in an ICMP echo failure three times.
B. The tracking return code fails after the SLA operation results in an ICMP echo failure one time.
C. After the tracking object fails, the tracking o bject moves back to an up state 45 seconds later in all cases.
D. After moving to a down state, the tracking object moves back to an OK state 45 seconds after the SLA operation moves to an OK state.
[单项选择] Router R1 exists in an Enterprise that uses EIGRP as its routing protocol. The show ip route command output on router R1 lists the following phrase: "Gateway of last resort is 1.1.1.1 to network 2.0.0.0". Whic h of the following is most likely to have caused this output to occur on R1?（）
A. R1 has been configured with an ip default- network 2.0.0.0 command.
B. R1 has been configured with an ip route 0.0.0.0 0.0.0.0 1.1.1.1 command.
C. R1 has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.
D. Another router has been configured with an ip default - network 2.0.0.0 command.
E. Another router has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.
[单项选择]The following routes exist in the Testking router（）
A. R 12.18.8.0/24 [120/1] via 12.18.2., 00:00:10, Serial0
B. R 12.18.11.0/24 [120/7] via 12.18.9.1, 00:00:03, Serial1
C. C 12.18.1.0/24 is directly connected, Ethernet0
D. R 12.18.5.0/24 [120/15] via 12.18.2.2, 00:00:10, Serial0
[多项选择] The following output was taken from Router R3. A scan of R3's configuration shows that no bandwidth commands have been configured in this router. Which of the following answers lists configuration settings could be a part of a configuration tha t results in the following output?（） R3#show ip ospf interface brief Interface PID Area IP Address/Mask Cost State Nbrs F/C Se0/0/0.2 3 34 10.10.23.3/29 647 P2P 1/1 Se0/0/0.1 3 34 10.10.13.3/29 1000 P2P 1/1 Fa0/0 3 34 10.10.34.3/24 20 BDR 1/1
A. An a uto - cost reference - bandwidth 1000 command in router ospf mode
B. An auto - cost reference - bandwidth 2000 command in router ospf mode
C. An ip ospf cost 1000 interface S0/0/0.1 command in router ospf mode
D. An auto - cost reference - bandwidth 64700 command i n router ospf mode
[单项选择]During startup, the router displays the following error message: boot: cannot open "flash:" What will the router do next（）。
A. Because of damaged flash memory, the router will fail the POST.
B. It will attempt to locate the IOS from a TFTP server. If this fails, it will initiate the setup dialog.
C. It will attempt to locate the IOS from a TFTP server. If this fails, it will load a limited IOS from ROM.
D. It will attempt to locate the configuration file from a TFTP server. If this fails, it will initiate the setup dialog.
E. It will attempt to locate the configuration file from a TFTP server. If this fails, it will load a limited configuration from ROM.
[单项选择] On a newly installed router, the following access list is added to the HSSI interface for incoming traffic:Access-list 101 permit tcp any 10.18.10.0 0.0.0.255 eq tcp What is the effect of the "any" keyword in the above access list?（）
A. check any of the bits in the source address
B. permit any wildcard mask for the address
C. accept any source address
D. check any bit in the destination address
E. permit 255.255.255.255 0.0.0.0
F. accept any destination
[多项选择] Router R1 has the following configuration. Assuming R1's F0/0 interface has a MAC address of 0200.0011.1111, what IPv6 addresses will R1 list for interface F0/0 in the output of the show ipv6 interface brief command?（） interface f0/0 ipv6 address 2345:0:0:8::1/64
A. 2345:0:0:8::1
B. 2345:0:0:8:0:FF:FE11:1111
C. FE80::8:0:FF:FE11:1111
D. FE80:0:0:8::1
[单项选择] Router R1 lists the following output from a show command. Which of the following is true about R1?（） R1# show ip v6 interface f0/0 FastEthernet0/0 is up, line protocol is up IPv6 is enabled, link - local address is FE80::213:19FF:FE12:3456 No Virtual link - local address(es): Global unicast address(es): 2000::4:213:19FF:FE12:3456, subnet is 2000:0:0:4::/64 [EUI] Jo ined group address(es): FF02::1 FF02::2 FF02::1:FF:12:3456
A. R1's solicited node multicast address is FF02::1:FF:12:3456.
B. R1's 2000::4:213:19FF:FE12:3456 address is a global unicast with all 128 bits statically configured.
C. Address FF02::2 is R1's solicited node multicast.
D. R1's solicited node multicast, not listed in this output, would be FF02::213:19FF:FE12:3456.
