更多"When the vessel entering the dock, "的相关试题:
[单项选择]A vessel is entering port A for the first time and has a Pilot conning the vessel. The Master is unsure that the Pilot is taking sufficient action to prevent a collision. What should the Master do().
A. Nothing; The Pilot is required by law and is solely responsible for the safety of the vessel
B. State his concerns to the Pilot but do not interfere with the handling of the vessel
C. Direct the Pilot to stop the vessel and anchor if necessary until the situation clears
D. Recommend an alternative action and if not followed relieve the Pilot
[单项选择]When a vessel is entering or leaving a port,a record of engine speeds is kept in the().
A. bell book
B. deck rough log
C. Official Logbook
D. engine rough log
[单项选择]A vessel is entering port “A” for the first time and has a Pilot conning the vessel. The Master is unsure that the Pilot is taking sufficient action to prevent a collision. What should the Master do? ()
A. Nothing; The Pilot is required by law and is solely responsible for the safety of the vessel
B. State his concerns to the Pilot but do not interfere with the handling of the vessel
C. Direct the Pilot to stop the vessel and anchor if necessary until the situation clears
D. Recommend an alternative action and if not followed relieve the Pilot
[单项选择]When passing a hawser to the dock you would first use what line().
A. Gantline
B. Heaving line
C. Preventer
D. Warp
[单项选择]When the dock is refilled with water after docking repair, the first work which should be done by engineers is ()
A. igniting boiler
B. releasing air in sea water system
C. starting generator
D. cut off shore power
[单项选择]When is dock survey carried out?()
A. During annual repair
B. Usually during dock repair
C. Before sea trial
D. After 5 years from last annual survey
[单项选择]The master of any vessel entering Singapore may () radio pratique to the Port Health Officer through his local agent.
A. apply to
B. apply for
C. apply with
D. apply in
[单项选择]A vessel entering the eye of a hurricane should expect().
A. moderating winds and heavy confused seas to strike his vessel from all directions
B. the winds to increase to hurricane force and strike from a different direction as the eye passes
C. the barometer to reach the lowest point
D. All of the above
[单项选择]When finish work on the oil separator, you should()firstly.
A. cut off the power
B. cut off the oil inlet
C. open guide water valve
D. close oil outlet value
[单项选择]()should you do first when heaving up the anchor.
A. Engage the wildcat
B. Release the brake
C. Release the pawl
D. Engage the motor
[单项选择]When ship in the dock repairing, engine department should emphasize on the inspection of()
A. sea valve chest, sect valve, thruster
B. bilge motherboard, steering and the shaft system
C. sea water system
D. fresh water system
[单项选择]During the dock repair, when installing the tail shaft and propeller, who should be on the spot to supervise?()
A. chief engineer
B. the engineer
C. captain
D. any member of the engine department
[单项选择]When required to work where there may be explosive gases, you should use tools which are ()
A. approved by the Coast Guard
B. high carbon steel
C. fixed with a ferrous cover
D. nonsparking
[单项选择]On a ship,when may a work vest be substituted for a required life preserver?()
A. To replace a damaged life preserver
B. For use during fire drills
C. For use during boat drills
D. At no time
[单项选择]On an OSV,when may a work vest be substituted for a required life jacket?()
A. To replace a damaged life jacket
B. For use during fire drills
C. For use during boat drills
D. At no time
[单项选择]When a vessel is in dry-dock, the vessel’s engineers should ().
A. examine the condition of the propeller
B. chip and paint all hull protection zincs
C. install new docking plugs in all cofferdams
D. inspect the hull for hogging or sagging
[单项选择]When discharging an oil cargo,the first consideration is to().
A. get the bow up
B. discharge from the wings first
C. discharge from the centerline tanks first
D. discharge from amidships first
[单项选择]When fighting an electrical fire, you should first ().
A. stop ventilation to the area
B. stop the vessel
C. secure electricity to the circuit
D. apply CO2 to the fire