题目详情
当前位置:首页 > 职业技能鉴定考试 > 轮机英语
题目详情:
发布时间:2023-10-20 12:36:42

[单项选择]The size of the discharge ring used for the efficient operation of a disk type purifier is dependent upon the()
A. rated capacity of that purifier
B. viscosity of the oil being purified
C. maximum design speed of that purifier
D. specific gravity of the oil being purified

更多"The size of the discharge ring used"的相关试题:

[单项选择]The word "discharge" as used in Pollution Prevention Regulations applies to oil ().
A. leaked into navigable waters
B. poured into navigable waters
C. pumped into navigable waters through a fixed piping system
D. all of the above
[单项选择]Ring groove inserts are occasionally used on aluminum alloy piston to()
A. reduce the ring groove wear rate
B. seal against crankcase vapors
C. lessen the wear on aluminum part of the cylinder
D. allow for the greater expansion rate of aluminum
[单项选择]A facility used for the discharge of a cargo of a particular hazard,such as chlorine,butane or ethane,must have what to warn water traffic of an immediate danger during fire or cargo release?()
A. An emergency boat and crew
B. A siren or rotating flashing light
C. Flashing red lights located one-half mile upstream and downstream of the facility
D. Buoys with flashing lights controlled from shore,located one-half mile upstream anddownstream of the facility
[单项选择]()are used to ensure that ships don’t discharge oil when pumping out oily water from any oil contaminated space.
A. Boiler
B. Incinerator
C. Oily water separator
D. Sewage treatment unit
[单项选择]Which factor determines the ring dam size for a fuel oil, tubular bowl type, centrifugal purifier?()
A. The viscosity off the fuel
B. The quantity of water to be removed from the fuel
C. The specific gravity of the fuel
D. The quantity of dirt to be removed from the fuel
[单项选择]A device used to enlarge the size of an existing bore hole, having teeth arranged on its outside circumference to cut the formation as it rotates is a (n)().
A. enlarge bit
B. casing bit
C. hole opener
D. casing opener
[单项选择]Badly leaking refrigeration compressor discharge valves will cause().
A. overfeeding of the expansion valve
B. damage to the condenser
C. constant running of the compressor
D. flooding of the receiver
[单项选择]If the discharge valves on a refrigeration compressor are leaking badly, the compressor should ().
A. run continuously
B. not start
C. have high discharge pressure
D. short cycle on the high pressure switch
[单项选择]The boiler feed pump discharge pressure is higher than the steam drum pressure to ().
A. ensure feed water flow into the boiler
B. keep the steam drum pressure high
C. prevent water hammer in the feed line
D. help the feed water flash to steam
[单项选择]The pump discharge pressure will be considerably higher than the pressure at the ().
A. pump entry branch
B. outlet pipe
C. impeller
D. None of the above is true
[单项选择]The major difference between the discharge and suction valves installed in most low pressure, reciprocating air compressors is that()
A. one valve seats upwards, while the other seats downwards
B. the reed valves used on the discharge are made substantially thicker and heavier than the suction valves
C. the suction valve springs exert a greater tension than the discharge valve springs
D. the discharge valve springs exert a greater tension than the suction valve springs
[单项选择]A seaman lost his continuous discharge book during the voyage. Upon discharge from Articles,he should be issued a().
A. letter of service on company letterhead signed and sealed by the master
B. Record of Entry in a Continuous Discharge Book for use in applying for a duplicate book
C. Certificate of Discharge with the white copy forwarded to the Commandant
D. Mutual Release (CG-2119),and the articles should be annotated as to the loss
[单项选择]If the compressor-discharge temperature is higher than the receiver temperature()
A. increase the amount of cooling water to the condenser
B. decrease the amount of cooling water to the condenser
C. add more refrigerant to the system
D. remove some of the refrigerant from the system
[单项选择]A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by ().
A. the four-way control valve failing to shift
B. the bleeder valve sticking in the open position
C. cold hydraulic fluid
D. a clogged air vent falter on the oil reservoir
[单项选择]When starting a centrifugal pump, the discharge valve should be ().
A. closed
B. opened fully
C. cracked open
D. partly open
[单项选择]Which is an exception to the garbage discharge requirements in Annex V to MARPOL 73/78?()
A. The garbage to be discharged will sink
B. Garbage accumulation on board has exceeded storage space
C. A person falls overboard,and a plastic ice chest is thrown for flotation
D. The destination port or terminal cannot receive garbage
[单项选择]The oil discharge monitoring system in the oil tanker vessels is used for detecting the amount of oil discharged overboard to ensure that it does not exceed()
A. 15 liters nautical mile
B. 30 liters nautical mile
C. 60 liters nautical mile
D. 100 liters nautical mile
[单项选择]An increase in the fuel injection pump discharge pressure can be caused by a/an ()
A. leaking delivery valve
B. excessive bearing end play
C. plugged injector spray hole
D. increased plunger stroke

我来回答:

购买搜题卡查看答案
[会员特权] 开通VIP, 查看 全部题目答案
[会员特权] 享免全部广告特权
推荐91天
¥36.8
¥80元
31天
¥20.8
¥40元
365天
¥88.8
¥188元
请选择支付方式
  • 微信支付
  • 支付宝支付
点击支付即表示同意并接受了《购买须知》
立即支付 系统将自动为您注册账号
请使用微信扫码支付

订单号:

截图扫码使用小程序[完全免费查看答案]
请不要关闭本页面,支付完成后请点击【支付完成】按钮
恭喜您,购买搜题卡成功
重要提示:请拍照或截图保存账号密码!
我要搜题网官网:https://www.woyaosouti.com
我已记住账号密码